ATON Source Input Wall PlateWallplate DHSIP Manual de instalación Pagina 10

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 48
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 9
8 ©2008 • All rights reserved.
DHSIP Source Input Wall Plate
Installation
The DHSIP is designed to mount in a standard single-
gang rough-in box (J Box). Mount the unit in close
proximity to the location of the source that will be
connected to it.
Note: Do not mount the DHSIP in the same
rough-in box as high voltage devices such as
electrical outlets or switches.
After running Cat-5 and terminating the ends, route
the wire into the back of the rough-in box, connect it
to the RJ-45 connector on the rear of the DHSIP, and
mount using the 2 provided screws. See Figure 2.2.
Screw
Screw
DHSIP
Rough-In
Box
Cat-5
Stud
Screw
Screw
Figure 2.2: Installing the DHSIP
Vista de pagina 9
1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 47 48

Comentarios a estos manuales

Sin comentarios